Description
The Sanicom 1 drain pump is used to pump gray water away from a variety of fixtures
in commercial applications. The system is able to discharge the waste up to 25 feet
vertical and/or 250 feet horizontal. This model was designed to sustain the toughest
applications in commercial installations where hot water can be an issue as it is capable
of handling up to 194°F as well as grease.
Features
- Discharges the waste through a 1” rigid pipe. The system includes a rubber discharge
fitting that adapts to the discharge pipe as well as a non-return valve.
Has been designed with a 1–1/4” vent connection on top of the system. All plumbing
codes require connection to a vent system. Please note that the vent system should be a
two-way air vent as air needs to freely flow both ways. Note: The use of mechanical vents,
air admittance valves or similar devices is not permitted. - Discharges gray water from commercial kitchens, dishwashers, washing machines, etc.
The gray water will drain into the system via two 2” inlets which are on either side of the
housing. Note that when draining wastewater into the pump through either of the side
inlets, an external check valve (not supplied) has to be installed. - Able to handle liquids with highly acidic properties as system activates with a fail proof
air pressure switch system with triple redundancy.
Specs
Max. horizontal discharge: 25 ft
Max. vertical discharge: 250 ft
Voltage: 120 V
Frequency: 60 Hz
Amperage: 8.3 Amps (Max)
Motor: 1/30 HP oil-filled thermally protected motor
Operating temperature: 194°F Max
Discharge pipe diameter: 1 ”
Capacity: 2.75 gallons
Inlets diameters: 2” (sides)
Type of activation: Pressure switch/ circuit board
Certifying agencies: CSA (IPC, NSPC)
